A new straight shaper design

I’ve been using a straight shaper for about two years that I had made for me to my specifications. Due to some unfortunate circumstances the original design was lost, but I have had Chip Owen at Fox measure the cane and re-create the shaper for me. The measurements match my original design specs perfectly, so I am confident this will be an accurate re-creation of this one original.

The shape itself is a unique blade contour. The first 15mm of the blade are similar to a Rieger 1A shape, but the blade stays much fuller through the throat and tube area, with a flare at the end of the tube. I typically place the 2nd wire 40mm from the fold and the 1st wire 32mm from the fold. I usually trim 2mm off of the end of the tube, but it can be left full length, allowing for an even greater bevel.

We’re taking orders for this shaper now at Midwest Musical Imports. I will have some pieces of gouged and shaped Gonzalez cane in this shape at the IDRS conference in New York in a few weeks.


Leave a comment

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s